Gates Powergrip® EPDM 1.5GT 6/9mm High Temperature Timing Belt Width:9mm Endures printing temperatures up to

Endures printing temperatures up to 290°C

M3x20 SHCS 18

The flange is made of a material with a low thermal conductivity to reduce the working temperature of the heat sink fixed with it by screws

20 x 2-pin PH male header

suggest drying before printing]

Gates Powergrip® EPDM 1.5GT 6/9mm High Temperature Timing Belt Width:9mm Endures printing temperatures up to9mm Width or 6mm Width with 1. 5mm pitch, depending on your selection Glass Fibre reinforced EPDM rubber belt A uniquely designed tooth profile distributes the load over the entire belt, allowing the belt to withstand greater loads Quiet, durable, and strong. Rated for 45C to 135C temperatures These are genuine Gates products, distributor certificate available on request from our supplier.